Asbestos is actually a silicate-based material that was commonly utilized in building construction for surfaces as common as walls or flooring tiles. The risk for many people who live or work in buildings with older flooring is that it is tough to understand if the building has asphalt tiles by simply looking.
Asbestos floor tiles are fairly typical in properties of a specific age and needn’t be a reason to fear, you may not even have to eliminate them. Nevertheless it pays to know how to spot them and asbestos floor tile removal is a serious business. Employing a licensed practitioner to remove asbestos tiles is the obvious choice but we will also look at how to eliminate them yourself and, just as importantly, the way to remove asbestos safely.
Let’s begin with a principle used in the floor and construction industries: If you think that it could be asbestos, then treat it as asbestos, even if the material has not been tested.
-Gather information concerning the time of the tiles: Asbestos flooring has been made into the 1980s, though its heyday was the 1920s through the 1960s. If you know when the building was constructed or renovated, this might help you estimate when the tiles were installed.
-Examine the state of the tiles: Intact asbestos tiles aren’t a significant risk and may, in actuality, be left in place and covered with different materials like carpet, vinyl, linoleum or concrete. Tiles that are disintegrating should be handled with extreme caution
-Look for discoloration: Asphalt is a principal ingredient in asbestos tiles, and the oil from the asphalt can leach out.
As you can see, this method isn’t an exact science. The only way to make it a science is to hire a licensed asbestos inspector or by sending a sample to a lab to be analyzed, but doing this can be costly and time consuming. Some might like to push ahead with good asbestos handling procedures.
Can I Eliminate Asbestos Myself?
Absolutely not, asbestos removal far from DIY friendly. Some do remove it themselves afterward burn/bury the material, but this is very ill-advised. Not only is that against the law but also incredibly dangerous. Hazardous fibers will almost certainly be published, posing serious dangers to anybody in the region.
Only qualified professionals with complete safety gear should be undertaking this job. It’s not prudent to place yourself and other people at considerable risk to cut costs.
The only way to be positive that your tiles contain asbestos is to have a sample tested by an accredited lab.
While there’s a good chance that 9-inch and 12-inch tiles manufactured before 1980 contain asbestos, the hazardous fiber is also found in bigger- and smaller-dimension tiles. Even the glue used to install the floor, particularly if it’s black “cutback” adhesive, could contain asbestos. The same concerns apply to vinyl and other sheet-type floors and attached fiber backing. According to the EPA, taking a sample for testing isn’t a do-it-yourself project. A professional familiar with asbestos should remove the sample and seal the removal region.
How much does it cost to remove asbestos tiles?
Possessing an independent inspector perform an initial asbestos inspection; the White Lung Association states this costs $400-$800 to an average 1,500 square foot home, including laboratory fees; along with a re-inspection in the end of the project can be $200-$400. If laboratory work is completed individually, a sample analysis averages $25-$75.
Removal prices vary widely depending on conditions. Removing a 10-foot section of asbestos pipe insulation could be $400-$650. Some contractors have a minimal fee of $1,500-$3,000, no matter how small the job is. And a whole removal in a 1,500 square foot house with asbestos everywhere–walls, ceilings, floors, attic, roof, pipes–could be as large as $20,000-$30,000.